Advertisement
1.
2.
3.
4.
2
Front bagger tube
_
_ F_ _
Lower bagger tube
""3
_
1/4 x 5O,8mm Carriage
Bolts
2
1/4 Lock nut
2
1.
Front bagger tubhe_iii_ilL
III\
_]
2.
1/4x50,8mmCarriage
_1_
Bolts
3.
1/4 Lock nut
4,
Vinyl Binding
5.
Dump handle tube
6,. Clevis pin
7.
Retainer
spring
6MM (1/4") - 9MM (3/8"
4
1
2
3
To Assemble
Bagger
NOTE:
For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
gether.
Assemble front and lower bagger tubes using four (4) 1/
4 x 5O,8mm carriage bolts and lock nuts supplied. Tighten
securely.
Slide front and lower bagger tube assembly
into the
bagger assemby.
Assemble front and upper bagger tubes using four (4) 1/
4 x 50,8m m carraige boltsand lock nuts supplied. Tighten
securely.
Slip all the vinyl bindings over the bagger tubes
•
Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin and secure with retainer
spring.
NOTE; For future use, the clevis pin may be removed in order
to use the handle to clear the chute in the event it has become
clogged.
Bagger
adjustment
For proper bag function and appearance, it may be neces-
sary to adjust the bagger assembly. There should be 6mm ( 1/
4")-9mm (3/8") gap between the bagger top and fender and
the bagger top surface should be even with the top surface
of the fender. To adjust bagger position:
Horizontal
adjustment
Slightly loosen the nuts securing the bagger RH and LH
horizontal adjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
Move the brackets the amount forward or backward you
wish the bag assembly to move. Retighten the nuts
securely.
1. Top Surfaces
Even
2.
3.
Vertical Adjustment Bracket
Vertical adjustment
Slightly loosen the nuts secudng the vertical adjustment
brackets. Loosen only enough so the brackets keep their
position, but allow them to be moved.
Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely,
Reinstall the bagger assembly and check the bagger to
fender fit. If necessa_!, repeat the procedure until proper
fit is attained.
To convert
to bagging,
mulching
or discharge
See "Section
5" of this manual.
3
1. Handle
2.
Retainer Spring
3.
Pin
4.
Plug
\
To assemble
and install mulcher
plug
Remove spring retainer and pin from handle.
Insert plug into handle. Make sure that the letter "A" on
both the plug and handle are on the same side and that
they can both be seen from the top when laying on the
ground.
Secure with pin and retainer spdng provided. For instal-
lation see "To Convert Mower" in Section 5 ofthis manual.
4
25
q
Advertisement
