Advertisement
2
_To
install
to tractor
bagger components
1.
Discharge
Chute
2.
3/8 Nut
3//
_
3.
Flat Washer
1.
2.
3,
4.
5.
6.
4
Rear Door
Support Bracket
2
3/8 Carriage Bolt
6
3/8 Lock Nut
3
318 x 63,5mm Hex Bolt
10,3ram
(13/32")
flat
washer
1
Remove discharge chute from rear oftractor. Unhook the
two (2) strops and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
1. 3/8 Lock nut
2.
Flat Washer
3.
Support Tube
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
While holding the rear door open, install the two upper
support brackets
through the back plate and to the
chassis, using the 3/8 x 19mm carriage bolts and Iocknuts
supplied. Tighten securely.
Assembte both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm hex
bolts13/32
I.D. flat washers and 3/8 Iocknuts from parts
bag. Tighten securely.
1,
Hook
2.
Discharge Chute _;
3.
Back plate slot
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor back
plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
24
Advertisement
