Depth Adjustment With Fixed Base; Coarse Adjustment; Fine Adjustments - Craftsman 320.28084 Product Manual

DEPTH ADJUSTMENT WiTH FIXED BASE (Figs. 13 and 14)
The fixed base is designed Fig. 13
with a micrometer-fine
adjustment system. When
the bit is lowered to the
F_
approximate position desired
(coarse setting), the system
may then be micro adjusted to E
the precise depth desired.
Coarse Adjustment:
Depressing the Coarse
Adjustment Knob (B) allows
you to quickly lower or raise
the cutting bit to one of three
depth settings.
Fig. 14
Fine Adjustments:
NOTE: Before making fine
adjustments, reset the Depth E
Indicator Ring to "0" (zero) B._
(E, Fig. 9).
The Depth Indicator Ring (E),
located on the Fine Adjustment
Dial (F, Fig. 9) is marked in
1/64-in. increments. Turning
the fine adjustment dial
clockwise 180 ° (1/2 turn),
lowers the cutting bit 1/16
inch. One full turn clockwise (360) to "0" (zero) lowers the bit 1/8 in.
The Depth Indicator Ring may be reset to "0" (zero) without moving the Fine
Adjustment Dial. This allows the user to begin adjustments from any reference point.
To Adjust Cutting Depth (Figs. 13 and 14)
1. Turn the router motor off and unplug it from the power source.
2. Place the router on a flat, level surface with the back of the fixed base facing
you. Open the Router Motor Clamp (A).
3. With the cutting bit installed, press in the Coarse Adjustment Knob (B).
4. Lower the router motor into the base until the cutting bit is very close to the
surface on which the base is sitting.
5. Turn the Fine Adjustment Dial (F) until the cutting bit just touches the flat
surface on which the base is sitting.
28084 Manual Revised 07-0712 Page 27