Adjusting Depth Of Cut; Three Mounting Positions For Auxiliary Handle Of D-Handle Base - Craftsman 320.28084 Product Manual

,_ WARNING: Always remove cutting bits from the collet/nut when the router is
not being used. Leaving bits installed could result in an accident causing serious
personal injury.
Three Mounting Positions For Auxiliary Handle Of D-Handle Base (Fig. 12)
There are three mounting
positions on D-handle base
for auxiliary handle (Fig. 12);
you can choose the desired
position to install the auxiliary
handle for ease of operation.
1. Turn the auxiliary handle
counterclockwise to loosen
it and remove the auxiliary
handle from the base.
2_
Align the screw on the
auxiliary handle with the
desired mounting hole
located on the left side of
the D-handle base.
3. Turn the auxiliary handle clockwise until it is firmly tightened.
ADJUSTING DEPTH OF CUT
WARNING: Your router should never be turned on or connected to the
power source when you are assembling parts, making adjustments, installing
or removing collets/nuts or cutting bits, cleaning, or when it is not in use.
Disconnecting the router will prevent accidental starting, which could cause
serious personal injury.
NOTE: All depth adjustments on the Fixed Base or D-Handle Base must be
made with the router motor clamp open.
NOTE: For the Fixed Base or D-Handle Base, the cutting bit depth equals the
amount of the cutter that is exposed below the surface of the sub-base.
28084 Manual Revised 07-0712 Page 26