Micro-Adjustments With The Depth-Stop Rod And Depth-Stop Turret; Toggle On/Off Switch - Craftsman 320.27669 Operator's Manual

To produce deep cuts, always make several progressively deeper cuts by
starting with the highest step on the depth-stop turret, and, after each cut, rotate
the turret to the next lower step until the lowest step is reached.
Each of the steps progresses by 1/4 inch increments. The 4 steps represent a total of
"0" inch to 3/4-inch with a full 360° rotation of the turret. Repeat this process if necessary.
Micro-adjustments with the Depth=Stop Rod and Depth=Stop Turret (Fig. 8)
The depth-stop rod has a micro adjustment
knob (A) that turns a screw (B) (inside the
rod) either clockwise or counterclockwise to
lower or raise the depth-stop rod on the turret
(C) for micro-fine adjustments of the plunge
depth.
Each complete revolution of the Micro-
adjustment knob adjusts the plunging depth
by approximately 1/32 inch.
A reference indicator line is embossed into
the depth-stop rod under the fine-adjustment
knob to set a reference point of "0".
When micro-adjust the plunge depth, always
make sure that the micro-adjustment knob
has been turned down (clockwise) several
revolutions from the top before setting the
depth-stop rod and depth-stop turret.
Fig. 8
Always set your micro-adjustments with the plunge action locked in the raised,
(or up) position.
To use the micro-adjustment knob after the depth rod and turret have been set,
check the final depth setting and micro-adjust as follows:
• To micro-increase the plunge depth, raise the micro-adjustment screw by
turning the knob counterclockwise the desired amount.
To micro-reduce the plunge depth, lower the micro-adjustment screw by
turning the knob clockwise the desired amount.
TOGGLE "ON/OFF" SWITCH (Fig. 9}
Your router motor is turned "ON" and "OFF"
by the toggle switch located on the top cap
of the motor housing.
The left side of the toggle switch hood (as you
face it) is marked 'T' for "On" and the right side
(as you face it) is marked "O" for "Off".
To turn the motor "ON", Push the toggle
switch to the left side marked 'T', or "On"
27669 ManuaLRevised_11 0215 Page 20