Using The Fence - Craftsman 137.219080 Owner's Manual

To prevent the werkpiecs or backup materia from being _orn
from your hands while dri_ing, you MUST _osition the
work£_ece against the LEFT side of the eokcmn. I:!the
workpiec_ or the backup mate rial _snot long enough to roach
the column, clamp them to the table or use the fence
provided w_ the drill press to brace _he workpieee. Failure to
sec_urethe workp_ece oould result in pe_nal inlury.
Fig, V
USING THE FENCE (FIG, V)
The fence provides a *way of accurately and quickly setting
up the workpiece for more precision or repetitive ddt_ing
operations.
1, Using the centerpunch or sharp nail make an
indentation in the workpiece where you want to dd&
2, Lower the dril_ bit to align w_th the indentation on the
3. Loosen the knobs (1) and slide the fence ba_ stop (2)
firmly against the _ong side of the workpJeceoT_ighten
the knobs when in position..
4 Loosen the wing nut {3) and s_lidethe e_ stop (4} along
the fence unti_ it is firmly against the ieft aide of the
wotkpiece, Tighten the wing nuL
5. Check the accuracy by driiiing a scrap workpiece.
Adjust it aeede&
& HoJd with your hand or damp _e top sLy#ace o_ the
workpi_e firmly to prevent it from lifting off the table
when _he bit is raised,