Fence Assembly - Craftsman 137.229151 Operator's Manual

INSTALLING THE HF.AD (FIG. D)
mvl/_d_ql K_
The Drill Press h_d Is very heavy and MUST be lifted
with the help of 2 PEOPLE OR MORE,to safely
assemble the Drill Press head on the column.
1. Carefully lift the head (1) above the column (2) and
slide it onto the column.Make sure the head slldea
down over the column as far as poealble.Algn the
head with the base.
2. Using the hex wrench, tighten the two head lock eat
screws (3) on the right side of the head.
Fig. D
"ry
J
_3
INSTALLING FEES HANDLES (FIG. E)
1. Locate three feed handles in the loose parts bag.
2, Screw the feed handles (1) into the threaded holes (2)
in the hub (3), Tighten
FENCE ASSEMBLY (FIG. F)
This drill press has a channeled table top.
1. Determine the desired location for the fence (1).Sllde
theT-blocks (2) Into the appropriate channels as
shown
2. Align the mounting holes of the fence over theT-block's
threaded hloes.
3. Place a washer (3) on the threaded end of the knob (4).
Insert the knob through the mounting hole of the fence
into the T-block,and Ugbetan.
4. Repeat for the other knob andT-block.
Fig. F
11