Circle Cutting; General Maintenance - Craftsman 320.28223 Operator's Manual

CIRCLE CUTTING (FIG. 22)
This requires using a circle
cutting / straight edge guide
sold separately.
1.
2.
3.
4.
Fig. 22
Before attaching the edge
guide, draw a circle and
drill a hole in the center of
the circle.
Drill or make a plunge cut
near the edge of the circle.
Turn off saw and
disconnect plug from
power source.
Attach the edge guide to
\
Center Poi_n¢
saw as instructed in USING AN EDGE GUIDE, with the edge guide facing up.
5. Place the metal center point on the edge into the hole in the center of the
circle. In order for the edge guide to cut a circle, the metal center point must
be in alignment with the saw blade.
6. Measure the distance from the selected hole to the blade; this distance is
equal to the circle radius.
7. Insert saw plug into power source.
8. Hold saw firmly, squeeze the trigger switch and slowly push the saw forward.
NOTE: To make a hole, cut from inside the circle; to make wheels or discs, cut
from the outside.
GENERAL MAINTENANCE
WARNING: When servicing, use only identical Craftsman replacement parts.
Use of any other parts may create a hazard or cause product damage. To ensure
safety and reliability, all repairs should be performed by a qualified service
technician at a Sears Parts & Repair Service Center.
,_ WARNING: For your safety, always turn off the switch and unplug the saw
motor from the power source before performing any maintenance or cleaning.
WARNING: Always wear safety goggles or safety glasses with side shields
during power tool operations or when blowing dust. If operation is dusty, also
wear a dust mask.
_L, WARNING: Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial solvents and may
be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
28223 Manual_Revised_S0 03S0 Page 28