Troubleshooting - Craftsman CMCS4000 Manual

BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
For assistance with your product, visit our website at www.craftsman.com for a list of service centers, or call the CRAFTSMAN
Customer Care Center at 1-888-331-4569.
PROBlEM
Unit will not start.
Battery pack will not charge.
Unit shuts off abruptly.
Saw makes unsatisfactory cuts.
Unit does not make accurate cuts.
Unit vibrates excessively.
Blade does not come up to speed.

TROUBLESHOOTING

POssiBlE CAUsE
Battery pack not installed properly.
Battery pack not charged.
Internal componets too hot.
Brushes worn out.
Battery pack not inserted into charger.
Charger not plugged in.
Surrounding air temperature too hot or too cold.
Battery pack has reached its maximum
thermal limit.
Out of charge. (To maximize the life of the
battery pack it is designed to shutoff
abruptly when the charge is depleted.)
Dull blade.
Not enough water in the resovoir.
Blade mounted backwards.
Build up on blade.
Incorrect blade for work being done.
Blade is not square to fence.
Blade is not perpendicular to cart surface.
Blade is bent or damaged.
Workpiece moving.
Saw not mounted on a level surface.
Damaged saw blade.
Blade arbor and nut are loose.
POssiBlE sOlUTiOn
Check battery pack installation.
Check battery pack charging requirements.
Allow tool to cool down.
Have brushes replaced by an authorized
CRAFTSMAN service center.
Insert battery pack into charger until LED lights.
Plug charger into a working outlet. Refer to
Important Charging Notes for more details.
Move charger and battery pack to a surrounding
air temperature of above 40 °F (4.5 °C) or below
104 °F (+40 °C).
Allow battery pack to cool down.
Place on charger and allow to charge.
Replace blade. Refer to Assembly for blade
replacement instructions.
Check water level and add water if necessary.
Turn blade around.
Use dressing stone to remove build up.
Replace blade. Refer to Assembly for blade
replacement instructions.
Check and adjust.
Check and adjust fence on sliding cart.
Replace blade. Refer to Assembly for blade
replacement instructions.
Use edge guide.
Reposition on a level surface.
Replace blade. Refer to Assembly for blade
replacement instructions.
Tighten blade arbor and nut.
English
13