Feeder Side Guide Adjustment - Oki proColor pro900DP Series Manual

Feeder Side Guide Adjustment

1.3
Note: For this step, the feeder should be in the Powered-Off state.
Step 2 is to set the feeder side guides so that they are positioned to
maintain uniformity in the media stack, without binding the media.
- Loosen the lock knobs for the guide (a), and adjust the side guides
with the center adjustment knob (b).
a)
- Place the 2" stack of media (in the desired orientation) in the hopper
and move the side guides approximately 1/16" from each edge.
- Tighten the lock knobs (a) to set the feeder side guides into place for
the initial feed test.
Next Step: Setting the wedge to support media stacking
______________________________________________________________________________________
Pro900DP Set-Up and Print Overview
b)
5