Initial Wedge Set-Up - Oki proColor pro900DP Series Manual

Initial Wedge Set-up

1.4
Note: For this step, the feeder should be in the Powered-Off state.
The purpose of the wedge is to
keep the bottom sheets in the media stack 'shingled'
redistribute the weight of the media stack
push the lower end of the stack against the gate assembly, so that
media can be separated.
- Loosen the wedge adjustment knobs.
- Make sure the 2" stack of 'pre-shingled' media is inserted into the
hopper between the feeder side guides, and set firmly against the gate
assembly.
- Slide the wedge until the bottom sheet of media is against the
belt/deck plate, and the rear ¼" edge of the sheet, is just on the
sloped surface of the wedge. Tighten the wedge adjustment knobs to
lock in place.
______________________________________________________________________________________
Pro900DP Set-Up and Print Overview
6