Oki GL408e Install Manual page 6

1) Removing the base of the printer (cont'd)
The front cover can now be removed.
Figure 1c. Front cover can now
be removed
Remove the lock shaft located at the front of
printer. (Do not lose this part as it is essential
for the installation of dispenser option)
Note
This lock shaft must be removed for the
successful installation of the internal
rewinder.
Figure 1d. Removing the lock shaft.
Remove a total of 9 screws (cross recessed
hexagonal bolt M4x10). Four screws are
circled in orange in Figure 1d.
Figure 1d. Removing the lock shaft.
6