Oki GL408e Install Manual page 9

2)
Mounting the printer above the rewinder-dispenser
To facilitate easier mounting, it is
recommended that you remove the front
cover of the internal rewinder-dispenser
beforehand.
Pull down the side cover of the internal
rewinder and remove two bind screws (M4x4)
located as shown within the orange circles.
Remove two bind screws (M4x4) located as
shown within the orange circles. Slightly lift
the front cover in the direction of the arrow a
little at a time, until it is totally separated from
the chassis.
Mount the printer chassis onto the internal
rewinder gently.
a) Make sure that no cables are sandwiched
between the printer chassis and internal
rewinder-dispenser chassis during
installation.
b)
Make sure that the sensor cable located at
the left bottom of platen roller at the front
of the printer (Fig 2c), is not caught in the
bracket during installation of the internal
rewinder-dispenser.
Side cover
Figure 2c. Make sure no cables are
compressed during the mounting.
9
ﾌﾛﾝﾄｶﾊﾞｰ
Front cover
図
Figure 2a. Removing the
rewinder's front cover
Figure 2b. Removing the
rewinder's front cover
Sensor cable