Oki GL408e Install Manual
Cutter install guide
Hide thumbs
Also See for GL408e:
- Install manual (15 pages) ,
- Manual (8 pages) ,
- Install manual (11 pages)
Related Manuals for Oki GL408e
Summary of Contents for Oki GL408e
- Page 1 CUTTER INSTALLATION GUIDE For printer models: 4xxe Series Read this Installation Guide before and during the installation of the above accessory. Keep this Installation Guide handy for future reference. For printer models:...
-
Page 2: Limitation Of Liability
Simple-Cutter Installation Guide 1 General 1.1 Important information This quick guide provides important information on how to setup your new SATO product. Be sure to read this quick guide thoroughly before using this printer. It is an integral part of the product and should be kept in the immediate vicinity of the device and available to the operating staff. -
Page 3: Explanation Of Symbols
Simple-Cutter Installation Guide 1.3 Explanation of symbols This instruction manual uses various warning icons to help you understand the safe operation of your printer. Explanations of the icons are below. WARNING! Indicates neglectful or erroneous use may cause irreparable damage to the product, serious injury to the operator, or worse. -
Page 4: Sato Group Of Companies
Simple-Cutter Installation Guide Contact and Document Information SATO GROUP OF COMPANIES International Headquarters Americas SATO INTERNATIONAL PTE. LTD SATO INTERNATIONAL AMERICA, INC. 438A Alexandra Road #05-01/04, (Regional HQ) Alexandra Technopark, Singapore 119967 10350 Nations Ford Road Suite A, Phone: 65-6271-2122 Fax : 65-6271-2151 Charlotte, NC 28273 Phone: 1-704-644-1650 Fax: 1-704-644-1662 Email: sales@sato-int.com... - Page 5 Simple-Cutter Installation Guide GL4xxe Label Cutter Installation The Label Cutter is housed in a cover assembly that is designed to replace the factory-installed front cover of the GL4xxe series printer. Follow the procedures below to install the Label Cutter. 1. Make sure the printer is OFF and disconnected from the power supply. 2.
-
Page 6: Online Mode
Simple-Cutter Installation Guide PRINTER CONFIGURATION FOR CUTTER OPERATION Once the Label Cutter has been installed, the printer automatically detects it. The cutter is not activated by default, except via the printer driver or via SBPL software commands. Dispenser setup via the LCD Menu Turn the printer ON and wait for it to initialize and go into OFFLINE ONLINE mode. - Page 7 Simple-Cutter Installation Guide...