Table of Contents
Advertisement
1)
Mounting the printer above the rewinder
A total of seven screws (cross recessed
hexagonal bolt M4x10) are used to install the
internal rewinder-dispenser to the printer
chassis
(Do not damage the PCB when using any tool
such as screwdriver)
Do not tighten all seven screws until you are
sure the installation alignment is correct. Also
check that all connectors have been
reconnected.
Two screws removed originally from the front
Figure 2d. Printer mounted on top of
of the printer, will be left unused.
the internal rewinder
Next, we will reinstall the front cover of the
ｺﾈｸﾀｰ
Connector
internal rewinder-dispenser.
First, connect the internal rewinder's cable to
the connector at the front of the printer, as
shown here.
Make sure it is not compressed in any way
when the front cover of the internal rewinder
Figure 2e. Connecting the internal
is mounted next.
rewinder signal cable
Reinstall the front cover of the internal
Four screws to be
rewinder and and temporarily tighten the two
secured in total
screws (bind screw M4×4) used to secure
each side of the front cover.
Figure 2f. Mounting the front cover
10
Advertisement
Table of Contents
