HP Surestore 6164 - Switch Reference Manual page 146

146
• offlineConnUnitPort:
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific offline operation.
Examples of these operations are:
– Disabling a ports transceiver
– Link Failure protocol
– Request (NONPARTICIPATING) command to the Loop Port state
machine
• onlineConnUnitPort:
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific online operation.
Examples of these operations are:
– Enabling a ports transceiver
– Link Failure protocol, request (PARTICIPATING) command to the
Loop Port state machine
– Addition of the port from an arbitrated loop by a hub
Each implementation can choose not to allow any or all of these
values on a set.
If the Management Station uses in-band communication (FC-IP)
with the switch, either of the two following actions can result in a
loss of in-band communication with the switch:
–Disabling the FC port that is connected to the Management Station
–Disabling the embedded port
Return values are as follows:
Note
resetConnUnitPort - portDisable (F or E, loop for U).
bypassConnUnitPort - portDisable (FL port).
unbypassConnUnitPort - portEnable (FL port).
offlineConnUnitPort - portDisable (E, F, FL).
MIB Reference Manual