HP Surestore 5200ex - Optical Disk Drives User Manual page 37

Problem What to Do
Unable to write to a
disk • Check power and connections. See "Drive won't power on"
discussed previously in this table.
• Does the host computer recognize the drive on the bus? See
"Host system does not recognize the drive" discussed
previously in this table.
• Is there a valid file system on the disk?
•
•
• Is the disk one of the following capacities: 2.3, 2.6, 4.6, or
5.2 gigabytes? This drive writes to only these capacities.
• If in Windows 3.x and using 1,024 bytes/sector disks—
refer to your application documentation to verify that your
application supports this sector density.
• If in Windows 95 or NT and using 1,024 bytes/sector
disks— boot your system with this density disk in the drive.
Continued on the next page
Chapter 3
If the disk does not have a valid file system,
you will receive an error message.
If the disk does not have a valid file system,
you must format the disk (Windows 95, NT) or
do a media init (HP-UX). For other Unix
systems, refer to your System Administrator's
Guide to prepare the disk.
Operating the Disk Drive
Troubleshooting
3-9