HP Surestore 5200ex - Optical Disk Drives User Manual page 34

Operating the Disk Drive
Troubleshooting
Problem What to Do
Host computer
system does not
recognize the drive •
•
•
•
•
•
•
•
3-6
Ensure the disk is connected and ON. (The disk must be ON
when booting the host computer for the disk to be
recognized.
The following steps attempt to bring the disk online without
booting the host computer system.
In Windows 95 and NT, rescan the bus.
- go to My Computer, Control Panel, System,
Device Manager (in 95), and SCSI
Controllers. Select the SCSI adapter where the
drive should be. Select Refresh.
In HP-UX, use SAM to verify that the drive is on the bus
and, if not, use SAM to install the driver.
- Follow the menus in SAM
For Unix systems other than HP-UX, refer to the System
Administrators Guide for diagnosing missing peripherals.
If the drive is the last one on the SCSI bus, check that the
drive has an terminator plugged into one of the cable
connectors (an active terminator is recommended).
Check SCSI ID assignments and resolve any conflict.
If steps above are unsuccessful, further information may be
on the optical web site at
www.hp.com/isgsupport/optical/index.html
If an answer is not on the web site, go to Appendix A for
further support information.
Chapter 3