HP Surestore 5200ex - Optical Disk Drives User Manual page 15

The following numbers correspond to the numbers in the drawing on the previous
page.
1 SCSI ID switch
2 Operation mode switch
3 Power connector
4 On/Off switch
5 SCSI connector (with
terminator attached)
6 SCSI connector (with
cable attached)
Chapter 1
Setting up the Disk Drive
Rear Panel Features
Used to set the SCSI ID. Refer to "Setting
the SCSI ID" in this section.
Used to choose the operating mode and set
your preference for write verify. Refer to
"Setting the Operation Mode" in this
section.
Receptacle for the power cord.
Used to switch power on or off.
50-pin high-density SCSI connector
(Micro D-type). Terminator may be
attached to either connector (see "6").
A terminator must be plugged into either
"5" or "6" when the drive is the last
physical device on a SCSI bus.
50-pin high-density SCSI connector
(Micro D-type). Cable may be attached to
either connector (see "5").
A terminator must be plugged into either
"5" or "6" when the drive is the last
physical device on a SCSI bus.
1-5