Exchange Databases - HP StorageWorks X5000 Release Note

Workaround This can be caused by the HDMonSvc service not reporting status to the Service
Issue:
Hardware RAID drive letter setup on DL100 G2 storage server
Description
Workaround Manually remove the drive letter from the DON'T ERASE disk using Disk Manager.
Issue:
A blue screen occurs on the DL100 G2 if rebooted during resynchronization of the storage volume
Description
Workaround A recovery of the storage server must be performed using the System Installation
Issue:
System time may differ from Summary screen of Rapid Startup Wizard
Description
Workaround Use the Date/Time property page to set the correct time.

Exchange databases

This section provides additional information regarding Exchange databases.
Issue:
Exchange System Manager—All Tasks option not available
Description
Workaround Close and then reopen the Exchange System Manager to make the All Tasks
14
Configuration
Control Manager. In this case it is an incorrect error. Check the event logs for
other services that may be reporting a failed condition.
The DON'T ERASE partition may have both a drive letter and a mount point
configured. This is not by design and may cause the data disk to not be formatted
or have a drive letter.
Format, add a drive letter, and label the data disk, if required.
If the DL100 G2 storage server (software RAID models only) is rebooted while the
storage volume in Microsoft Disk Management displays a "Resynching" status, a
blue screen may occur on the storage server during startup.
WARNING!
Do not shut down or reboot the DL100 G2 storage server (software
RAID models only) when actions have been taken using Microsoft Disk
Management to resynchronize the storage volume, and the volume status
displays "Resynching." Wait until the storage volume displays "Healthy"
before rebooting or shutting down the system. Resynchronization may take
some time, depending on the size of the volume. Although you can access a
volume while synchronization is in progress, do not make any configuration
changes to the storage during resynchronization.
and Recovery DVD.
The system time shown in the Summary screen of the Rapid Startup Wizard may
differ from the actual system time after completing the wizard. This occurs when
the system time has not been changed in the Date/Time page, but a different
time zone has been selected.
Exchange databases
If the Exchange System Manager is open when installing the Feature Pack
or the Exchange server, you may receive an error stating that the Exchange
System Manager should be closed. The All Tasks command is not available in
the drop-down menu that displays when a storage group in Exchange System
Manager is right-clicked.
option available.