Table of Contents
Advertisement
To view the currently selected status after it has been
transmitted, press the
button prior to the time-out period. If the status was not
sent successfully to the site, the text associated with the
status will flash in the display.
The radio can also be pre-programmed to redesig-
nate the keypad buttons for ST0 thru ST9 to send status
condition. In this configuration the radio status operation
will operate as previously described except the
key is not required.
Message Operation
Message operation permits the transmission of a
pre-programmed message text to an EDACS site.
To send a message, press the
one of the number keys (
pre-programmed message text. If no message text has
been programmed for the selected number key, the radio
will display "NO ENTRY". A valid selection will permit the
message text to appear in the display for a pre-pro-
grammed time. After the time-out expires or the
key has been pressed (the
time-out period), the message text is selected and will be
transmitted to the site. If the site does not receive the
message properly, the radio will sound a low pitched
tone.
If an incorrect message text was selected or the
incorrect number key was pressed, the message text
can be changed during the pre-programmed time-out
period by pressing another number key. The message
86
key and then the CLEAR
key then press
) to select the
key will override the
Advertisement
Table of Contents
