Table of Contents
Advertisement
When in the pre-stored list, pressing
the Logical IDentification (LID) on and off.
Sending An Individual Call (Trunked Mode Only)
The following procedures describe how to initiate and
complete an individual call.
1. To select a previously stored individual, select the
I-Call mode from the menu or press
by the RAMP control
through the list of stored individuals. The selection
mode rules apply. While in the individual call list, the
key will toggle the display between the call
name and the unit ID number. If the individual is not
stored in this list but the individual's unit ID is known,
it can by entered directly from the keypad.
2. Press the PTT button; the radio performs the neces-
sary signaling to obtain a communication channel.
When the signalling is complete and the radio is clear
to transmit,
access tone sounds. Line one shows the called
individual's name if found in the list of stored individu-
als or ID followed by the logical ID number of the unit
being called. The message *INDV* displays on line
two. Proceed with the message.
XMIT
indicator turns on and the channel
toggles
followed
or
to scroll
75
Advertisement
Table of Contents
