Installing The Card; Connecting The Card - Dell PowerEdge UPS 500T User Manual

Installing the Card

The Dell Network Management Card can be installed in any Dell UPS equipped with a communication
bay without turning off the UPS or disconnecting the load.
To install the Dell Network Management Card:
1
Remove the communication bay cover from the UPS. Retain the screws.
2
If not already done, record the card's MAC address for future reference (see "Installation
Checklist" on page 9).
3
To prevent electrostatic discharge (ESD), place one hand on a metal surface.
4
Slide the card into the open slot and secure with the screws removed in Step 1 (see Figure 4).
Figure 4. Installing the Card

Connecting the Card

To connect the card to the computer and start the configuration:
1
Plug the RJ-45 end of the supplied serial cable into the Settings port on the card (see Figure 5).
NOTE:
You can set the card parameters through the Settings port even if the network is not connected. The
Ethernet port on the card does not work for configuration.
2
Plug the other end of the serial cable into the serial COM port on the computer.
|
12
Getting Started