Setting The Speakers And Subwoofer Information Manually - JVC RX-ES1SL Instructions Manual

Speaker settings
When selecting "MEDIUM ROOM,"
• Center speaker delay time
is set to1 msec.
• Surround speakers delay time
is set to 2 msec.
/
When selecting "LARGE ROOM,"
• Center speaker delay time
is set to 0 msec.
/
• Surround speakers delay time ,,
is set to 0 msec. "
[]
Settingthe speakersandsubwoofer
information manually--Manual Setup
You can set the foflowing speakers and subwoofer information
manually as you prefer• When you change your speakers, register the
information again.
Subwoofer information--SUBWFR
Speaker size--FRNT SP, CNTR SP, SURR SP
Speaker detay time--CNTR DL, SURR DL
Crossover frequency--CROSS
Low frequency effect attenuator--LFE
Dynamic range compression--D.COMP
Operating procedure
Onthe front panel ONLY:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step f again.
1 Press SETTING.
MULTi JOG now works for the setting operation•
2 Turn MULTI JOG until the setting item you want
to set appears on the display, then press SET.
• As you turn MULTI JOG, the indication changes as foflows:
,::' i i D i.i i:" D L.i i:" ,:- _o_
..: :..: 1_: :;._1 1".. az I ".., .J
3 Turn MULTI JOG to select the appropriate setting
for the item selected in step 2, then press SET.
Your setting is stored.
ANACO_ L ___
="1 Ir"=l Ir-'l-'= n LI="= -.'_
.") I..I [:) I.I.I r- !% :: p! I..I _oL
EX: When selecting "NO" for "SUBWFR."
4
If you would like to set other items, repeat steps
2 and 3.
Setting the subwoofer information
--SUBWFR (subwoofer)
Register whether you have connected a subwoofer or not.
YES*: Select when you have connected a subwoofer.
The subwoofer speaker indicator (SUBWFR) l ights up
on the display (see page 14). You can adjust the
subwoofer output level (see page 21).
NO: Select when you have not connected or have
disconnected a subwoofer.
* Initial setting
Setting the speakers size
--FRNT SP (front speakers), CNTR SP (center
speaker), SURR SP (surround speakers)
Register the sizes of all the connected speakers•
LRG (large): Select when the cone speaker size is larger than
4 3/4inches (12 cm).
SML (small)*: Select when the cone speaker size is smaller than
4 3/4inches (12 cm).
NO: Select when you have not connected a speaker. (Not
selectable for the front speakers.)
* Initial setting
• Ifyouhaveseiected"SML(smafl)"forthefrontspeakersize, you
cannot select "LRG (large)" for the center and surround speaker
sizes.
• If you have selected 'NO" for the subwoofer setting (see above and
page 16), you can only select "LRG (large)" for the front speaker
size.
(Back to the beginning) CONTINUED ON THE NEXT PAGE
17