Tuner Operations; Settingthe Am Tunerintervalspacing; Tuningin To Stationsmanually; Usingpresettuning - JVC RX-ES1SL Instructions Manual

Tuner operations
The buttons on the remote control are mainly used for tuner
operations. To use buttons on the remote control, press
FM/AM before operation.
When operating this receiver using the remote control,
always set the mode selector to AUDIOfTV/VCR/DBS.
Settingthe AM tunerintervalspacing
Some countries space AM stations 9 kHz apart, and other countries
use 10 kHz spacing. 9 kHz interval spacing is the initiai setting.
• Be sure the receiver is turned off, but is plugged into an AC outlet
when setting the AM tuner interval.
On the front panel ONLY:
To select the 10 kHz interval:
Hold down ADJUST and press STANDBY/ON O/I.
To change back to the 9 kHz interval:
Hold down SETTING and press STANDBY/ON O/I.
Tuningin to stationsmanually
Fromthe remote controlONLY:
1 Press FM/AM to select the band.
The test received station of the selected band is tuned in.
• Each time you press the button, the band alternates between
FM and AM.
...... I" 1',4 i"1 "?1 _i I"I MH 2_' _
!" !'! ¢. 3 , = .. I..I _oL
You can also select "FM" or "AM" by turning SOURCE SELECTOR
on the front panel.
2
Press repeatedly or hold TUNING _]_ or
TUNING _ until you find the frequency you
want.
If you select "FM" or "AM" using SOURCE SELECTOR on the
front panel, press FM/AM on the remote control before this
operation.
• Pressing (or holding) TUNING _]_ increases the frequency.
• Pressing (or holding) TUNING _ decreases the frequency.
• When you hold and release TUNING _]_ orTUNING _, the
frequency keeps changing until a station is tuned in.
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
• When an FM stereo program is received, the ST (Stereo) indicator
also lights up.
Usingpresettuning
Once a station is assigned to a channel number, the station can be
quickly tuned.You can preset up to 30 FM end 15 AM stations.
To store the preset stations
Before you start, remember...
There is a time limit in doing the following steps, if the setting is
canceled before you finish, start from step 2, again.
Fromthe remote controlONLY:
!
Tune in to the station you want to preset (see
"Tuning in to stations manually" above).
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See "Selecting the FM
reception mode" on page 24.
...... i'."iYi (3 ,:', "1:" i "i _o. 2ri
I I I i.j i,=i • .==ii,=i
2 Press MEMORY.
The channel number position starts flashing on the display for
about 5 seconds.
ANACO_ L __*
I" II1_ _t_ ,",4 !.-! ":. i i " 20
%.......- %...... VOL
CONTINUED ON THE NEXT PAGE
23