Connecting The Speakers - JVC RX-ES1SL Instructions Manual

Getting Started
Connecting the speakers
Turn off all components before connections.
Speaker LayoutDiagram
After connecting the front, center and surround speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best
)ossible surround effect. For details, see pages 15 to 18.
speaker
RX=ES1SL
\
\
\
Right surround
speaker
Connecting the front, center, and surroundspeakers
For each speaker, connect the (+) and (-) terminals on the rear panel
to the (+) and (-) terminals marked on the speakers respectively.
1 Twist and remove the insulation at the end of each
speaker cord (not supplied).
2 Press and hold the clamp of the speaker terminal (_1_),
then insert the speaker cord ((2_).
3 Release the finger from the clamp.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Powered subwoofer
Connecting the subwoofer
By connecting a subwoofer, you can enhance the bass or reproduce
the originai LFE signals recorded in the digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
You can place a subwoofer wherever you like since bass sound is
non-directionaL Normaily place it in front of you.
2
3
@ To center speaker
_'_ To right surround speaker
© To left surround speaker
@ To right front speaker
IE'_TO left front speaker
6