Nikon COOLPIX P7100 Reference Manual page 91

If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
• See "Error Messages" (_107) for more information.
Power, Display, Settings Issues
Problem Cause/Solution _'_
Batteryis exhausted.
24
if no operations are performed for a while, camera has 25
Camera turns off turned off automatically by auto off to save power,
inside of the camera has become hot, Leave the camera
without warning, off until the inside of the camera has cooled,
At low temperatures, the camera and the battery may not _)]- 3
function normally,
Camera is off, 25
Battery is exhausted. 24
Standby mode for saving power: Press the power switch, 25
shutter release button or the [] button, or rotate the
mode dial,
Monitor is blank.
Monitor is turned off, Press the I1_1 button to tum it on. 1S
Camera and computer are connected via USB cable. 91
Camera and TV are connected via A/V cable or HDMI 91
cable.
Interval timer shooting in progress. 54
Ambient lighting too bright: Use viewfinder or move to 16
darker location,
Monitor is hard to
Adjust monitor brightness. 16, 104
see. Monitor is dirty. Clean monitor.
_:_. 6"'-
Use monitor brightness boost.
16
The viewfinder is
hard to read. Adjust diopter adjustment control. 16
If the camera clock has not been set ("Date not set" 26, 104
indicator blinks during shooting), recording date and
Date and time of time is recorded as "01/01/11 00:00." Set the correct date
recording are not and time using Time zone and date in the setup menu.
correct. The camera clock is not as accurate as a normal clock, 104
such as watches, Check camera clock regularly against
more accurate timepieces and reset as required.
No information Shooting information and photo information may be
displayed in hidden. Press the ]IZ}I button until shooting information or 15
monitor, photo information is displayed,
2-