Nikon COOLPIX L15 User Manual page 111

Cleaning
Avoid touching glass parts with your fingers Remove dust or lint with a blower
(typically a small device with a rubber bulb attached to one end that is
pumped to produce a stream of air out the other end) To remove fingeTpdnts
Lens or other stains that cannot be removed with a blower, wipe the lens with a soft
cloth, using a spiral motion that starts at the center of the lens and working
toward the edges If this fails, clean the lens using a cloth lightly dampened
with commercial lens cleaner
Remove dust or lint with a blower To remove fingerprints and other stains,
Monitor clean the monitor with a soft, dry cloth, being careful not to apply pressure
Use a blower to remove dust, dirt or sand, then wipe gently with a soft, dry
cloth. After using the camera at the beach or seaside, wipe off any sand or salt
Body with a dry cloth lightly dampened with fresh water, then d/y thoroughly Note
that foreign matter inside the camera could cause damage not covered by the
warranty
Do not use alcohol, thinner, or other volatile chemicals.
Storage
Turn the camera off when not in use, Check that the power-on lamp is off before
putting the camera away. Remove the batteries if the camera will not be used for
an extended period. Do not store the camera with naptha or camphor moth balls,
or in any of the following locations:
• Next to equipment that produces strong electromagnetic fields, such as
televisions or radios
• Exposed to temperatures below 10 °C (14 °F)or above SO°C (122 °F)
• Poorly ventilated or subject to humidities of over 60 %
To prevent mold or mildew, take the camera out of storage at least once a month.
Turn the camera on and release the shutter a few times betore putting the camera
away again.
[] Notes on the Monitor
• The monitor may contain a f_w pixels that are always lit or that do not light This is a characteristic
common to all TFT LCD displays, and does not indicate a malfunction Images recorded using the
product will not be affected
• When framing bright subiects, vertical comet like streaks that whiten toward either end may
appear in the display This phenomenon, known as "smear; does not appear in the final
photograph and does not indicate a malfunction Some smear may appear in movies
• Images in the monitor may be difficult to see under bright lighting
• The monitor is lit by an LED bacHight Should the monitor begin to dim or flicker, contact your
Nikon authorized sewice representative
z
o
g9