Olympus STYLUS 1050 SW Instruction Manual page 67

Before Use:
Check the camera for foreign material
including dirt, dust or sand.
Be sure to close the battery/card compartment
cover and connector cover firmly so that each
lock makes clicking sound.
Do not open the battery/card compartment
cover and connector cover with wet hands,
while under water, or in a damp or dusty
environment (e.g. beach).
Use the camera underwater with the lens
barrier in the down position. To turn the
camera on and off undewvater, use the POWER
button.
After Use:
Do not slide the lens barrier up until the
camera has been rinsed with water.
Be sure to wipe off any excess water or debris
after using the camera under water.
After the camera is used under seawater,
immerse the camera in a bucket containing
fresh water for about 10 minutes (with
the batteryteard compartment cover and
connector cover flrmBy dosed). After
that, dry the camera in a shade with good
ventiBation,
* Water drops may be observed on the inner
surface of the battery/card compartment
cover or connector cover after you open
each cover, If any water drops are found,
be sure to wipe them off before using the
camera,
Notes after use
Foreign materials may be attached to the
periphery of the lens barrier from using the
camera in conditions with foreign materials
such as dirt, dust or sand, or when the lens
barrier is not moving smoothly. If you continue
to use the camera in such conditions, the lens
could become damaged or the lens barrier
could stick causing additional damage to the
camera. To avoid such damage, wash the
camera using the following method.
(_ Insert the battery and close the battery/
card compartment cover and connector
cover firmly so that each lock makes the
clicking sound.
_) Fill a bucket with fresh water, immerse
the camera in the bucket with the lens
surface downward and shake the camera
thoroughly
,3_Rinse the front of the camera with running
water while the lens barrier is open
Follow Steps ,1 to ,_, then check if the lens
barrier moves smoothly. If the lens barrier does
not move smoothly, rinse the lens barrier by
placing it directly under fast running water
Storage and _laintenance
* Do not leave the camera in an environment at
high temperature (40°C (104°F) or more) or at
low temperature (-10°C (!4°F) or less). Failure
to do so may break down water resistance
. Do not use chemicals for cleaning, rust
prevention, anti-fogging, repairing, etc. Failure
to do so may break down water resistance.
* Do not leave the camera in water for a long
time, FaiBure to do so wHB cause damage to
the camera's appearance andlor deteriorate
water resistance.
* In order to preserve the water resistant
feature, as with any underwater housing,
it is recommended that the waterproof
packing (and seaBs) are replaced annually,
For the Olympus distributors or service
stations where the waterproof packing can
be repJaeed, visit Olympus website for your
local area,
EN