Olympus STYLUS 1050 SW Instruction Manual page 58

If the camera does not work as intended, or if
an error message is displayed on the screen,
and you are unsure of what to do, refer to the
information below to fix the problem(s).
battery is instaIBed"
e Insert recharged battery in the _onect d}rectib_
"Chargi°g thebatter€' (p._0i:::: _di.g
the battery and the xD-Picture
separately} into the camera" (p. 11)
e Battery performance may have been reduced
temporarily due to low temperature Take the
battery out of the camera, and warm it by putting it
in your pocket for a while•
C,r #ntern J memor
"An error message is displayed"
"Error message" (p, 59)
® Set the mode dial to a position other than [_},
GUIDEand -k.
® Wait until _(flash charge) stops blinking before
taking pictures
Monitor
"Difficult to see"
® Condensation*_ may have formed. Turn off the
p....... d wait for th........ 6Qdy to b......
acclimated to the surrounding t_m_ _tgre aad dry
out before taking pictures
"_ Dew drops can form in the camera when it is
suddenly taken from a cold location into a warm,
humid room
"VerticaB Hnes appear on the screen"
® 'Vertical lines may appear on the screen at
times such as when the camera is pointed at an
extremely bright subject under a clear sky. The
lines do not appear, however, in the final image
"The Hght is caught in the picture"
® Shooting with flash in dark situations results in
an image with many flash reflections on dust in
the air
Shutter button
"No picture is taken when the shutter
button is pressed"
e Slide the lens barrier down t
=z
e Cancel sleep mode
To save battery power, the camera automatically
goes into sleep mode and the monitor turns,off
if there is no operation after 3 minutes whenthe
camera is turned on (when the lens barrier is
open and the monitor is on). No picture is taken
even if the shutter batten is fully pressed in this
mode Operate the zoom button or other buttons to
restore the camera from sleep mode before taking
e picture. If the camera is left for 15 minutes, it
automatically turns off (the monitor turns off). Slide
the lens barrier down again or press POWER to
turn the camera on
• If the battery is removed and left out of the camera
for about 1 day *s, the date and time settings return
to the default setting and must be reset•
-2 The time until the date and tree settings return
to the default setting varies depending on how
long the battery have been loaded.
"Setting the date and time" (p. 13)
EN