Grounding Instructions - Waring PRO MX1000R Instruction Booklet

• For your protection, this appliance is equipped with a 3-conductor cord set.
• 120 Volt units are supplied with a molded 3-prong grounding-type plug
(NEMA 5-15P) and should be used in combination with a properly connected
grounding type outlet as shown in Figure A.
If a grounding type outlet is not available, an adapter, shown in Figure B,
may be utilized to enable a 2-slot wall outlet to be used with a 3-prong plug
(except in Canada and Europe). As shown in Figure C, the adapter must be
grounded by attaching its grounding lug under the screw of the outlet cover
plate.
Caution: Before using an adapter, you must be sure that the outlet cover
plate screw is properly grounded. If in doubt, consult a licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
Note: Use of an adapter is not permitted in Canada and Europe.
Green/Yellow: Earth/Ground. Blue: Neutral. Brown: Live.
Note: User installed cord set plugs are not permitted in Europe.
MX1000R ( Model: MXMPBKP6 ) OPERATION
1. Before starting, make sure that the blender is unplugged.
2. With the unit in OFF position, place container on blender base.
Be sure container is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
3. Put ingredients into container and cover it. Do not
fill above MAX line.
4. This blender has 2 speed settings: HI and LOW.
Press paddle switch to desired position. To crush
ice quickly, use HI speed setting.
5. When finished blending, set paddle switch to
OFF position.
6. This blender is equipped with a pulse option. Hold
paddle switch in the lower position to engage
PULSE function. Unit will run on HI speed until the
paddle switch is released.

GROUNDING INSTRUCTIONS