Craftsman 320.21195 Operator's Manual page 20

SQUARINGTHE
BLADETO '_' " _&_ J
THE FENCE (Fig. 4) \ \_\ _ Fig. 4
unplug your saw could result in
accidental starting causing
serious njury, _
I Set the bevel and miter angles to
0 _' degrees, _ _
2 Lower and lock the saw arm into _i._._'_ '=4:_
the "DOWN" position " . ,_
the square against the blade, "_ ._)) F.nco
and the rule of the square J t_ Locking
against ths fence, _,_L_ _1 8o_ls He×
square against the body of the |
blade and not against the teeth /
of the blade. J
4 {f the blade Is not 90" to the fence,
toosen the two fence locking bolts
AdIust the fence gO ° to the blade.
When blade is gO" square to fence, re-tighten the two fence Iock{ng botts Use a
6 mm Hex Key to foosen and tighten the fence lock{ng boils,
NOTE: If the saw has not been used recently, recheck blade squareness to
the fence and readlust If necessary.
MITER ANGLE INDICATOR
ADJUSTMENT (Fig, 5) If Necessary
& WARNING:
Failure to unplug I
your saw could result In accidental
starting causing serious Injury,
1 Place the miter table at 0 _ and lock in
p_ace
2 Loosen the miter angle Indicator screw
and adjust the indicator to the "0" mark
on the miter scale (Fig 5)
3, T_ghten the miter angle indicator screw
2O