Download Print this page

Depth Stop Adjustment - Craftsman 320.21195 Operator's Manual

9 amp 7 1/4-in. compound miter saw with laser trac
Hide thumbs

Advertisement

ADJUSTtNGTHE
BLADETOTHE
MITER TABLE 45 _Bevel, 0"MITER (F}g_ 8)conL
7 Once t he angle i sset, t ighten the lock nut w ith the wrench while h olding the set
screw i nplace w ith the hex key
8 Lock t he bevel knob
BEVEL ANGLE INDICATOR
ADJUSTMENT
(Fig. 9)IfNecessary
1 Check losee ifthe bevel angle i ndicator
ts
pointing to45" onthe bevef scate
2 Ifthe indicalor
isnot o n 45 °.Ioosen the bevel
angle i ndicator
screw, adjust the indicator
to45 _onbeve_ angle scale, Iighlen screw
,VOTAOJOST °TS
1
J
circumstances
do not require
readjustment.
Saw ArmTravef
P_vet Adjustment:
Your saw arm should rise (travel) completely
to the up position by ttsell
/k WARNING:
TO avoid risk of personal
injury, if your saw arm does not rise "t
by Itself or if there is play in the pivot Joints, have your saw serviced
at a Sears 1
Service Center before using°
1
Bevel Pivot Adjustment:
Your miter saw arm should beret easily by loosening the bevel lock knob and tilting
the saw arm to the _eft
z_ WARNING:
"re avoid risk of personal
injury, if movement is tight or if
t
there is play in the bevel pivot, have your saw serviced
at a Sears Service
J
Center before using_
DEPTH STOP ADJUSTMENT
(Fig,. 10) If Necessary
The deplh stop Iimtls the downward travel of the blade It allows the blade to go below
the miter table enough Iomaintain full cutting capacities
NOTE: The miter tabte support
ts located under the miter
table and throat
plate.
The depth
stop is factory
set to provide
maximum
cutting capacity for the
711,_-tnch blade Included
with your saw.Therefore
the blade Included
with
your saw should
never need adjustments,
When a new blade Is installed,
tt Is necessary
to check the clearance
of the
blade to the miter
table support (see Fig. 10a on page 24) before
starting
the saw. Make adjustments
If necessary.
23

Advertisement

loading

  Related Manuals for Craftsman 320.21195