Craftsman 320.21195 Operator's Manual page 13

Chamfer Cut
A cut removtng a wedge from a block of wood so the end (or part of the end} is
angled at other than 90 _'
Ripping or Rip Cut
A cutting operation along the length of the workpiece
Freehand Cut
Performing a cut without using a fence, miter gauge, fixture, work clamp, or other
proper device to keep the workpiece from twisting or moving during the cut,
Through Sawing
Any cutting operation where the blade extends completely through the thickness of
the workpiece
Non-Through Cuts
Any cutting operation where the b}ade does not extend comptetely through the
thickness of the workptece,
Kerf
The material removed by the blade in a through cut or the siot produced by the blade
in a non-through or partial cut
Kickback
A hazard that can occur when the blade binds or stalls, throwing the workptece
back toward operator
Workplece or Matertal
The Item on which the cutting operation is being done The surfaces of a workpiece
are commonly referred to as faces, ends and edges
Gum
A sticky, sap-based residue from wood products
Resin
A sticky, sap-based substance that has hardened
13