Hose Clamp - Craftsman 486.24707 Operator's Manual

• Assemble the adapter bracket to the deck using two
5/16" x 1-1/4" hex bolts, 5/16" flat washers and 5/16"
nylock nuts. See figure 28.
NOTE: It may be necessary to use extra 5/16" flat
washers to shim under the bracket next to the deck
surface. Ten extra washers have been furnished as
shims. See figure 28.
(2) 5/16" NYLOCK
i
@_ NUTS
1_---- (2) 5116"FLAT
WASHERS
ADAPTER BRACKET
5/16" x 1-1/4" _"_
HEX BOLT
5116" flat washers
used as needed for
shims to adjust for
variations in decks.
FIGURE 28
With deck adapter positioned correctly over the
discharge opening, use the adapter bracket as a
template and drill three 9/32" diameter holes in the
top of the deck adapter. See figure 29.
Bolt deck adapter to bracket using three 1/4" x 3/4"
bolts, nylon washers, 1/4" flat washers and 1/4"
nylock nuts. Nylon washers should be against the
inside of the deck adapter. See figure 29.
DECK ADAPTER
_ (3) 1/4" NYLOCK
NUTS
BRACKET
WASHERS
(3) 1/4" STEEL WASHERS
(3) 1/4" x 3/4" HEX BOLTS
FIGURE 29
Assemble end of hose and a hose clamp over the
round opening of deck adapter and tighten clamp.
GO DIRECTLY TO THE OPERATION
INSTRUCTIONS ON PAGE 18.
Call 1-866-576-8388 for missing parts or assembly help 1 7
DO NOT RETURN TO STORE