Hose And Wand Storage; Diffuser Assembly - Craftsman 113.179255 Owner's Manual

Assembly (continued)
Hose and Wand Storage
1. Slide the extension wands on either
side of the Vac for storage. The storage
rack accommodates both extension
wands.
2. Wrap the Pos-I-Lock® hoses around
the upper storage rack as shown.
Hose Storage
Wand _ Rack
Storage
\
NOTE:
The Pos-I-Lock ® hose has an
adaptor that can be used to connect the
hose to the female port on the Vac or to
the male end of another hose. Both 7 foot
and 14 foot hoses can be used either
connected together or independently from
one another.
The 14 foot hose has a locking adaptor at
one end that will connect to the Vac, and
a friction fit connector at the other end,
which will connect to all the 17/8 inch
accessories or a second hose.
The 7 foot hose has a locking end at both
ends of the hose. The larger of these
ends is sized to connect to the Vac or to
the friction fit end of the 14 foot hose and
the smaller of these ends is sized to lock
to all the 17/8 inch accessories.
To connect these two hoses together, first
connect the 14 foot hose to the Wet/Dry
Vac. Next connect the 7 foot hose to the
14 foot hose by inserting the friction end
of the longer hose into the larger locking
end of the shorter hose. This will create a
friction connection.
Diffuser Assembly
Connect the lanyard to the attachment
tab on the vac motor assembly to keep
the diffuser attached to vac when using
the blower port. The diffuser cap can be
used in the exhaust port of the Wet/Dry
Vac. Installing the diffuser cap will allow
you to diffuse the exhaust air in any
direction and reduce the intensity of the
exhaust force.
Attachment
_Tab
Female
on Vac
Adaptor _ / Male End
10