Insert Hose; Accessory Storage; Cord Storage; Hose Storage - Craftsman CMXEVBE176060 Instruction Manual

Insert Hose (Fig. K)
Insert the Locking End of the Hose into the Vac Inlet Port.
The Hose should snap into place.
To Remove the Hose from the Vac, press the Release
Button in the Hose Assembly and pull the Hose out of the
Vac Inlet Port, as shown.
Fig. K
Accessory Storage (Fig. L)
Your Craftsman Wet/Dry Vac Accessory Storage is located
at the rear of the Vac.
There are Nine Storage Locations on the Accessory Storage
and One Storage Location on each Caster Foot.
Fig. L
SP7092-1 12 & 16 GALLON.indb 9
PRESS
& PULL
Release
Button
Accessory
Storage
Caster Storage
Cord Storage (Fig. M)
Wrap the Power Cord around the Cord Tabs located on the
Detachable Blower. Snap the Power Cord into the Cord
Clip to secure.
Fig. M
Cord
Clip
Cord
Wrap
Cord
Tabs (2)
Hose Storage (Fig. N)
The Hose may be stored by wrapping it around the
Powerhead Assembly and positioning the Hose through
the Accessory Storage Unit and securing the Hose End into
the Caster Foot Storage.
Fig. N
Hose
Caster
Foot
Storage
9
9/13/19 9:07 AM