Epson 5 Reference Manual page 63

6 - PerpToMidPnt Calculate the position on the 2nd line where the 2 lines intersect in a perpendicular
fashion through the mid point of the first line and use this position as the end point.
7 - PerpToEndPnt Calculate the position on the 2nd line where the 2 lines intersect in a perpendicular
fashion through the end point of the first line and use this position as the end point.
If the EndPointObject is modified to a Line object then the EndPointType is automatically changed to
MidPoint.
If the EndPointObject is modified to Screen or Blob, Correlation, Edge, or Point object then the
EndPointType is automatically changed to 0 - Point.
See Also
Edge Object, EndPointObject Property, Line Object, Object Tab, StartPointType Property
Vision Guide 5.0 Reference (Ver.5.3) Rev.1
EndPointType Property
49