Unpackthe Pressure Washer; Carton Contents; Install Wheel Kit - Craftsman 580.752030 Operator's Manual

Your p ressure washer requires some assembly and is ready
foruse onlyafter i t hasbeen properly serviced withthe
recommended oilandfuel.
tf
yon have any prnNems with the assembly of your
pressurewasher, please call the pressurewasher hempline
at 1o800o222o3136.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1o800o222o3136.
° Main Unit
° Handle
, Wheel Kit
, High Pressure Hose
, Spray Gun
, Adjustable Nozzb Extension
, Oil Bottle
° Parts Bag (which includes the following):
, Operator's Manual
, Owner's Registration Card
, Safety Goggtes
* Mesh Accessory Bag
Becomefamiliar with each piece before assembling the
pressure washer. Identify aiI contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer hetp%e at 1o880-222o3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. FilI out and send in registration card.
2. Attach handIeto main unit.
3. Instali wheel kit.
4. Add oii to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water suppiy to pump.
8. Attach nozzle extension to spray gun.
Attach Handle
1. Placehandle (A) onto base (B). Make sure holes in
handle align with holes on base.
2. Insert carriage bolts (g) through holes from outside of
unit and attach a plastic knob (D) from inside of unit.
Tighten by hand.
install Wheel Kit
The wheel kit is designed to greatiy improve the portabifity of
your pressure washer.
NOTE:Wheel kit is not intended for over-the-road use.
install the wheel kit as faiiews:
1. Placethe bottom of the pressure washer frame on a flat,
even surface.
2. Slide a wheel (A) over the axle pin (B).
NOTE:Be sure to install wheel with raised hub inboard.
/
I
/
3. Slide axle pin through hole (C) in frame.
4. Retain wheel on axle pin with retaining pin (D).
5. Repeatstep 2 through 4 to secure second wheel.