Craftsman 580.752030 Operator's Manual page 9

Connect Hose and Water $uppty te Pemp
4. Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
iMPORTANT:DO NOT siphon standing water for the water
supply. Use ONLYcoid water (iess than IO0°F).
5. Connectgarden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTE:Remove and discard the shipping caps from the
pump's high pressure outlet and water intet before attaching
hoses.
1. Uncoil higil pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
_ quipment produces can cut througll skin and its
underlying tissues, ieading to serious injury and
_ossible amputation.
* NEVERconnect high pressure hoseto nozzle extension.
* Keep high pressure hose connected to purnp and spray gun
while system is pressurized.
, Always be certain spray gun, nozzles and accessories are
correctly attached.
Attach other end of high pressure hose to higI1pressure
outlet on pump. Tighten by hand.
3. Beforeconnecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged. 00 NOTrue pressure washer if
inlet screen is damaged or missing.
Using a OneWay Valve (vacuum breaker or check valve) at
inlet can cause pump or inlet connector darnaqe.
ThereMUSTbe at leastten feet of unrestricted gardenhose
between thepressurewasherinletand anydevice,suchas a
vacuumbreaker o r checkvalve.
Damage to equipment r esultingfrom failureto followthis
instructionwill void warranty.
6. Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
VARNING
>/_-_l_ Risk of eye injury=
_Spray_ can sp ash back or propel objects.
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
ChecMist Before Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Be sure to read Safety Ru/es and Operationsections
before using the pressure washer.
2. Make sure handie is in place and secure.
3. Checkthat oii has been added to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5= Checkfor proper hose connections (high pressure and
water suppiy) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceed IO0°F).