Unpackthe Pressure Washer; Carton Contents - Craftsman 580.752181 Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
Attach Handle and Accessory Tray
1. Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
CARTONCONTENTS
Checka]] contents, if any parts are missing or damaged, cail
the pressure washer helpline at 1-800-222-3136.
* Main Unit
* Handle
* Accessory Tray
* High Pressure Hose
* Spray Gun
* Spray Tip Extension with Quick Connect Fitting
* Oil Bottle
* Parts Bag (which includes the following):
* Operator's Manual
* Owner's Registration Card
* Safety Goggles
* Bagcontaining 3 multi-colored Spray Tips
* HandleFasteningHardwareKit (which includes):
* Carriage Bolts (2)
* Plastic Knobs (2)
, Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGPRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach spray tip extension to spray gun.
8. Select/attach quick connect spray tip to spray tip
extension.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (D) through holes from inside of
unit and attach a plastic knob (E) from outside of unit.
Tighten by hand.
3. Placeaccessory tray (F) over holes (H) on handle
(viewing from front of unit). Push the tree clips (6) into
the holes until they sit fiat against the accessory tray.
\
Insert multi-colored Quick Connect spray tips and other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.