Warranty - Craftsman 580.752030 Operator's Manual

Add Engine OiJ
1. Place pressure washer on a fiat, Ievei surface.
2. Cleanarea around oii fiii and remove yeiiow oii fiii
cap/dipstick.
NOTE:See Oil Recommendations in Maintenancesection.
Verify provided oii bottle is the correct viscosity for current
ambient temperature.
3. Using oil funnel (optional), slowiy pour contents of
provided oil bottie into oil fill opening.
NSTICE
improper treatment of pressure washer can damage it and
shorten its life.
DONOT attemptto crankor sta!t the enginebeforeit hasbeen
properlyservicedwith the recommended o il. This may resultin
an enginefailure.
4. Replace oil fill cap/dipstick and fully tighten.
Add Faei
Fuel must meet these requirements:
, Clean, fresh, unteadedgaso%e.
, A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
o Gasoline with up to 10% ethanol (gasohoi) or up to 15%
MTBE (methyi tertiary butyl ether) is acceptable.
WARNING
Fueland its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
WHENADDINGFUEL
,,, Turnpressure washerOFF and let it coolat least2 minutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure
in tank.
• Fillfuel tankoutdoors.
o DONOToverfilltank.Allowspacefor fuel expansion.
• If fuel spills wait until it evaporates beforestartingengine.
Keepfuelawayfrornsparks,openflames,pilot lights,heat,and
otherignitionsources.
DONOTlight a cigaretteor smoke.
Cieanarea around fuel fiii cap, remove cap.
Siowiy add regular unleaded fuel (A) to fuet tank (B). Be
carefui not to overfiii. Aiiow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
®
1.
2.
Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabiiizer when adding fuei. See Storage. Ali fuel is not the
same. if you experience starting or performance probiems
after using fuei, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoiine. The
emission control system for this engine is EM (Engine
Modifications).
3.
Install fuel cap and wait for any spilled fuel to evaporate.
CAUTJSN!AlcohoI-biended fuels (catied gasohoI, ethanol or
methanol) can attract moisture, which leadsto separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine probiems, the fuet system should be treated
with a fuel preserver or emptied before storage of 30 days or
longer, if adding a fuel preserver, fili the fuel tank with fresh
fuei. if only partialiy tiffed, air in the tank wiii promote fue!
deterioration during storage, if fuel preserver is not used,
drain the fuel tank, start the engine and iet it run untii the fuel
lines and carburetor are empty. Use fresh fuei next season.
See Storage for additional information.
NEVERuseengine or carburetor cteaner products in the fuel
tank as permanent damage may occur.
High Altitude
At aititudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compiiant, high aititude adjustment is
required. Operationwithout this adjustment wiii cause
decreasedperformance, increased fuet consumption, and
increased emissions. See a qualified Sears dealer for high
altitude adjustment information. Operation of the engine at
altitudes beiow 2,500 feet (762 meters) with the high altitude
kit is not recommended.