Connecting The Scanner To Your Computer - Epson GT-9600 User Manual

Connecting the Scanner to Your Computer

For PC users:
Unless your PC already has a SCSI board installed, you need to
install one, along with SCSI driver software. Install the SCSI board
according to the directions included with the board. Also see
"Installing a SCSI Interface Board (Windows Only)" on page 1-6.
If your PC has a SCSI board up and running, connect the scanner
as described in the next section.
Note:
You will need to install the SCSI driver that is normally included with
Windows 95, 98, or NT (see your system documentation for
instructions), or the driver described in the SCSI board installation
documentation.
For Macintosh users:
Conventional Macintosh computers have built-in SCSI ports;
therefore you do not need to install a SCSI board on a Macintosh.
Follow the directions below to connect your scanner and
computer.
1-10
Setting Up the Scanner