Craftsman 24919 Operator's Manual page 8

42 in. two bin rear bagger for revolution zero-turn tractor

Hide thumbs Also See for 24919:

Available languages

Assemble Mounting Brackets

Toassemblethe baggermountingassembly,locatethe hitch bracket

kit and follow thesesteps:

Attachthe right-handand left-handrider hitchbracketto the

universalrearattachmentbracketusingthe four carriagebolts

(710-0276) and flange lock nuts(712-04063)from hardware

pack689-00097. Positionthe bracketswith the notcheson the

right-handand left-handrider hitch bracketsand the tabs on the

universalrearattachmentbracket,pointingupwards.See Fig. 1.

Flipoverassemblyand mountthe hitch supportbracketto the

mountingassemblyusingfour 710-3008 hex bolts and 712-04063

flangelock nuts from hardwarepack689-00097.See Fig.2 for

properorientation.

NOTE: Whenattachingthehitch support,it is best to notfully tighten

the bracketat this time. This willfacilitatethe mountingprocessin

later steps,whichwill then requirefully tighteningof this hitch support

bracket.

NOTE:This universalmountingbracketassemblyis designedto

workwith otheravailableattachments,such as a weightkit used in

conjunctionwith the snowblade or snowthrowerattachment.Utilize

thecontact informationon the back page,or contactthe store in

whichyou purchasedthis equipment,to find out moreaboutavailable

attachments for your specifictractor.

Figure 2

NOTE:Packedwith the uprightmountingbracketare two mounting

bracketswith hardwareusedon anothermodeltractorand will notbe

neededin this installation.Simplydiscardthe parts shownbelowin

Fig.3.

Figure 1

Figure 3