Advertisement
General
Care & Cleaning
(cont'd)
Removing
and Replacing
the Lift-Off
Oven Door
The door is heavy. For safe, temporary storage, lay the door fiat with
the inside of the door facing down.
Door Hinge locations
with oven door fully open
Fig. 1
Fig. 2
Oven
Fig. 3
Fig. 4
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor - See Fig. 1).
2.
Pull the door hinge locks on both left and right door hinges down from the oven
frame completely towards the oven door (See Fig. 2). A tool such as a small flat-
blade screwdriver may be required.
3.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle - See Fig. 3).
4.
Close the door to the broil stop position (the oven door will stop into this position
just before fully closing).
5.
With the oven door in the broil stop position, lift the oven door hinge arms over
the roller pins located on each side of the oven frame (See Fig. 4).
To Replace Oven Door:
1.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle - See Fig. 3).
2.
Holding the oven door at the same angle as the removal position, seat the hook
of the hinge arm over the roller pins located on each side of the oven door frame
(See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins.
3.
Fully open the oven door (horizontal with floor - See Fig. 1).
4.
Push the door hinge locks up towards and into the oven frame on both left and
right oven door hinges (See Fig. 2) to the locked position.
5.
Close the oven door.
Special
Door Care Instructions
= Most oven doors contain glass that can break.
Read the following recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching, hitting, jarring or stressing the glass may weaken its structure
causing an increased risk of breakage at a later time.
To Remove the "Hidden
Bake" Cover (somemodels)
1.
in order to remove the "hidden bake" cover, pull the back edge with one hand
about Y2 inch and lift up the "hidden bake" cover with both hands. (See picture)
2.
When re-installing the "hidden bake" cover, be sure to put it all the way to the
back of the oven and lay it down on the 2 shoulder screws. Then push the front
edge of the cover in its place below the front bracket.
To have easier access to the "hidden bake" cover, you can remove the oven door by
following the instructions on previous page.
IMPORTANT: Always replace the "hidden bake" cover before the next use.
24
Advertisement
