Replacing The Doors - GE 20 Owner's Manual And Installation Instructions

Installation Instructions
REPLACING THE DOORS
(Double Door Refrigerator Models only)
m INSTALL CENTER HINGE
Install the center hinge on each side.
[]
[]
REHANG REFRIGERATOR DOORS
Lower the refrigerator door onto the
center hinge pin. Ensure that the white
hinge pin thimble is on the center hinge
pin or inside door hinge pin hole located
in the bottom of the door.
Hinge Pin
Thimble
[]
[]
Securely tape the door shut with
masking tape or have a second person
support the door.
Route wires through top hinge pin slot.
Insert the top hinge pin into the hinge
hole on top of the refrigerator door. Make
sure the door is aligned with the cabinet
and opposite door. Attach the hinge to
the top of the cabinet loosely with the
bolts.
•
(appearance may vary
[] Reconnect the wire connector and
reconnect the ground wire using the
screw removed earlier. Ensure that the
wire connector is fully engaged.
IMPORTANT: The ground wire must be
reinstalled to ensure a proper ground.
Wire _ _'_/)/,_
Con
Ground Wire __
[] REHANG REFRIGERATOR DOORS(CONT.)
[] Make sure the gasket on the door is
flush against the cabinet and is not
folded. Make sure the door is straight and
the gap between the doors is even across
the front. While holding the aligned door
in place, tighten the top hinge bolts.
Replace the hinge cover and screw.
Hinge Cover -------__
REPLACE OPPOSITE DOOR
Follow the same procedure on the
opposite door.
[33
ALIGN DOUBLE DOORS
If the top of the doors are uneven, first
try to raise the lowest door by turning the
leveling leg on the same side as the door
until the doors are even. If the unit rocks,
re-adjust the leveling legs to the extent
that the unit is stable.
If the doors remain uneven, use a C
spacer to align the doors. While lifting
the door on the hinge side with one hand,
insert a C spacer with pliers. Continue to
add C spacers until the doors are even.
Spacer
[] REPLACE FREEZER DRAWER
Refer to the Replacing the Freezer Drawer
section for instructions.