Maintenance; Specifications - Sharp DK-AP2 Operation Manual

Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet or on
the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on until normal playback is possible (about 1 hour).
Wipe off any condensation on the transmitter with a soft cloth before
operating the unit.
If trouble occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1 Set the unit to the stand-by mode and turn the power on again.
2 If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
Before transporting the unit
Remove the iPod from the unit. Then, set the unit to the power stand-
by mode. Carrying the unit with iPod left docked might damage both
the unit and the iPod.

Maintenance

Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
Do not apply oil to the inside of the unit. It may cause
malfunctions.

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
General
Power source DC 6V: AC/DC Adaptor (AC 100 - 240V,
50/60Hz)
DC 3V: "AA" size (UM/SUM-3, R3 or HP-7) x 4
Power Power on : 3.8 W
consumption Power stand-by: 0.2 W*
Output power Speakers:
RMS: 3.8 W (1.9 W + 1.9 W) (10% T.H.D.)
Speaker 1-way type speaker system
Speakers: 5 cm (2") - 6 ohms - Full Range
Speaker maximum Speakers: 3.8 W/Channel
input power
Speaker rated Speakers: 1.9 W/Channel
input power
Output terminals Video output: 1Vp-p
Input terminals Auxiliary (audio signal):
500 mV/47 k ohms
Dimensions Width: 380 mm (15")
Height: 157 mm (6-2/5")
Depth: 221 mm (8-7/10")
Weight 1.2 kg (2.65 lbs)
* This power consumption value is obtained when in the power . .
stand-by mode.
DK-AP2
DK-AP2(BK)
13