Table of Contents
Advertisement
Other operation
Modes and exit trays
Types of exit trays
An optional finisher can be installed to increase the number of exit trays.
Only the machine
G
Center tray (with offset function)
G
Job separator tray
With finisher
G
Center tray (with offset function)
G
Top tray
G
Offset tray
Exit tray when job interrupt occurs
When a print job (copy or auto print job) is interrupted, the output from each print job is routed to
the exit tray selected for that job in order to distinguish between the interrupted job and the inter-
rupting job. If both jobs specify the center tray or the offset tray, which both have the offset function,
the output position of the interrupting job is offset with respect to the output position of the interrupt-
ed job. When the interrupting job ends, the interrupted job resumes with output at its original posi-
tion.
Notes
G
The exit tray for a print job can be set from the key operator program. For details, refer to
the operation manual for copy mode.
G
The offset function of the center tray and the offset tray can be turned on or off using the
key operator program.
G
When the finisher is installed, output goes to the top exit tray if the machine only has copy
mode, or if there is no output job that specifies the top tray as the exit tray.
Department control and changing modes
When department control is turned on, pages printed by each department can be tracked. Depart-
ment control is turned on and account numbers stored using the key operator programs of each
mode. Department control is explained in the operation manuals of each mode.
When department control is turned on and the mode is changed, "Enter your account number" ap-
pears in the display. You must enter your account number.
Changing to another mode from copy, fax, or scan mode
If the account number before the mode change is the same as the account number after
the mode change, the mode can be changed. If not, the account number must be entered.
Changing from print mode to another mode
The account number must be entered.
Changing to print mode
An account number need not be entered.
Note
G
The print mode key operator program can be used to restrict the execution of print jobs to
account numbers stored in the department counter of copy mode.
14
Advertisement
Table of Contents
