Table of Contents
Advertisement
Operation when an error occurs
Error table
When an error occurs during a job, the error immediately appears in the display. The job is inter-
rupted if the error affects the job; otherwise, the job continues. In the case of a walkup job, if the
error does not affect the job, the error message appears after the job is completed.
If an error occurs that requires a service call, the machine stops immediately and an error code
appears.
Errors and operation
When an error occurs, many jobs become impossible; therefore, the error should be cleared as
soon as possible.
Misfeed in machine
The display shows "Clear paper path."
G
The mode cannot be changed until the error is cleared.
G
The JOB STATUS key can be used.
G
Memory scanning is possible.
G
Data transmission is possible.
Notes
G
When the error is cleared, the job that was in progress before the error occurred resumes.
G
A fax or scan job that is being scanned or that is stored will be executed, but new scan-
ning cannot be started.
Misfeed in SPF or RSPF
The display shows "Clear paper path."
G
The mode cannot be changed until the error is cleared.
G
The JOB STATUS key can be used.
G
Memory scanning is possible.
G
Data transmission is possible.
G
Print and fax print jobs are possible.
Notes
G
When the error is cleared, the job that was in progress before the error occurred resumes.
The display shows the number of original pages that need to be reloaded. Reload those
pages and press the START key.
G
If a print job or fax print job is in progress, printing continues. Subsequent print jobs can
also be started.
Open machine cover
A message appears in the display prompting you to close the cover.
G
Operation in this case is the same as "Misfeed in machine".
Open SPF or RSPF cover
When a job is set up that uses the SPF or RSPF, a message appears in the display prompting you
to close the cover.
G
Any job that does not use the SPF or RSPF is possible.
11
Advertisement
Table of Contents
