Care And Maintenance; Main Unit; Filters - Sharp FU-40SE Operation Manual

CARE AND MAINTENANCE

(To maintain the best performance of this product, please clean the unit periodically.)
When cleaning, be sure to remove the power plug from the wall outlet. In addition, never
handle the power plug with wet hands.
Electrical shock and/or bodily injury may occur as a result.

MAIN UNIT

For soiling on the main unit and the installed
surface, clean as early as possible. Stubborn
dirt may be hard to remove.
Dry wipe with a soft cloth
For stubborn dirt, wipe with a soft cloth damp-
ened with water or warm water of 40 C or less.
Do not use volatile fluids
Benzene, paint thinner, polishing powder, etc.,
may damage the unit surface.
Do not use detergents
Detergent ingredients may damage the unit
surface.
Do not get wet
Never apply water on the unit.
ODOR SENSOR
DUST SENSOR
The sensitivity of the sensors will be come
unstable if the odor or dust sensor is dirty or
blocked.
Remove dust on the surfaces of the sensor
openings using a vacuum cleaner.
Odor sensor Dust sensor
E-12

FILTERS

Clean using the nozzle of a vacuum
cleaner without removing the pre-filter.
NOTE
Never wash or clean the HEPA filter or
stamina-power carbon by directly con-
tacting the nozzle of a vacuum cleaner.
This will greatly decrease the perform-
ance of the filters.